However, devices will only be shown by their INSTEON hex address (e.g., “1A.2B.3C”) which can be a bit unwieldy. This will expose all the supported INSTEON devices which exist in the modem’s ALL-Link database.
#INSTEON CAMERA SETUP GUIDE PASSWORD#
The only configuration item that is necessary is the PLM port or Hub IP address, username and password so that Home Assistant can connect to the INSTEON Modem. Insteon Terminal is a very useful tool but please read the disclaimers carefully, they are important. SmartHome no longer supports HouseLinc, but it still works.
#INSTEON CAMERA SETUP GUIDE DOWNLOAD#
Alternatively, you can download HouseLinc, which runs on any Windows PC, or you can use Insteon Terminal which is open source and runs on most platforms. Please see the documentation on the pyinsteon GitHub site. If you are looking for more advanced options, you can use the insteon_tools command-line tool that is distributed with the pyinsteon Python module.
If the IM is a responder, press the SET button on the device then put the IM into linking mode. If the IM is a controller, put the IM into linking mode then press the SET button on the device. The IM can be set as a controller or a responder. insteon.add_all_link: Puts the Insteon Modem (IM) into All-Linking mode.The Insteon Modem module supports All-Linking through Developer Tools service calls. For an overview of device linking, please read the Insteon page on understanding linking. In order for any two Insteon devices to talk with one another, they must be linked. In order for a device to be discovered, it must be linked to the INSTEON Modem as either a responder or a controller.
If for any reason this approach does not work, you can add the device to a device override in configuration options from the integrations page inside the configuration panel. You may need to trigger the device a few times. If a device is not recognized during autodiscovery, trigger the device, such as toggling a button, to force the device to send a message to the modem.
Subsequent startups will occur much quicker using cached device information. The first time autodiscovery runs, the duration may require up to 60 seconds per device. You can configure the Insteon integration by going to the integrations page inside the configuration panel. It has also been tested to work with the 22 Hubs. It is known to work with the 2413U USB and 2412S RS242 flavors of PLM and the 2448A7 USB stick. There is currently support for the following device types within Home Assistant:ĭevice support is provided by the underlying pyinsteon package. This integration adds “local push” support for INSTEON Modems allowing linked INSTEON devices to be used within Home Assistant.
0 kommentar(er)
